Special Tool - Hand Tester: 57001-1394
For the switch housings and the ignition switch, refer to the tables in the Wiring Diagram.
If the switch has an open or short, repair it or replace it with a new one.
Rear Brake Light Switch Connections
Sidestand Switch Connections
Oil Pressure Switch Connections*
*: Engine lubrication system is in good condition.
Crankshaft Sensor Peak Voltage Inspection
Refer to the Crankshaft Sensor Peak Voltage Inspection
in the Electrical System chapter.
If the reading is within the standard, remove the ECU and
check the wiring for continuity between harness connectors.
Special Tool - Hand Tester: 57001-1394
Disconnect the ECU and sensor connector ...
Stick Coil Installation
Apply a thin coat of grease [A] to the stick coils for easy
installation.
Insert the stick coils so that the coil heads align with the
lines [B] on the cylinder head cover.
NOTICE
Do not tap the coil head while installing the coil.
After installation, be sure the stick coils are ...
KIBS Hydraulic Unit Inspection
Remove the KIBS hydraulic unit (see KIBS Hydraulic Unit
Removal).
Visually inspect the connector terminals [A].
Replace the KIBS hydraulic unit or main harness if either
of the terminals are cracked, bent, or otherwise damaged.
If the KIBS hydraulic unit connector is clogged with mud
or ...