Kawasaki Ninja Service Manual: Tail/Brake Light (LED) Removal/Installation

Kawasaki Ninja Service Manual / Electrical System / Lighting System / Tail/Brake Light (LED) Removal/Installation

Remove: Upper Seat Cover (see Seat Cover Removal in the Frame chapter)
Disconnect the tail/brake light connector [A].

Tail/Brake Light (LED) Removal/Installation

Remove: Tail/Brake Light Mounting Screws [A] Bolts [B] and Brackets [C] Bolt [D]

Tail/Brake Light (LED) Removal/Installation

Remove the tail/brake light [A].

Bring down the rear fender rear [B] lightly to clear the hook [C] from the tail/brake light.

Tail/Brake Light (LED) Removal/Installation

Installation is the reverse of removal. Note the following.

Fit the hook [A] to the tail/bake light.

Fit the tab [B] of the tail/brake light as shown in the figure (both sides).

Tighten: Torque - Tail/Brake Light Mounting Screws: 1.2 N·m (0.12 kgf·m, 11 in·lb)

Tail/Brake Light (LED) Removal/Installation

When installing the damper [A] on the clear lens of the tail/brake light [B] so that the damper positions between corner and corner of the lens as shown in the figure.

Tail/Brake Light (LED) Removal/Installation

City Light (LED) Removal/Installation

Remove: Upper Fairing Assembly (see Upper Faring Assembly Removal in the Frame chapter) Headlight (see Headlight Removal) Remove the screws [A], and take the city light [B] off the upper ...

License Plate Light Bulb Replacement

Remove: Screws [A] License Plate Light Cover [B] Pull the bulb [A] out of the socket [B]. NOTICE Do not turn the bulb. Pull the bulb out to prevent damage to the bulb. Do not use ...

Other materials:

Coolant Flow Chart
1. Radiator 2. Radiator Fan 3. Water Pump 4. Oil Cooler 5. Oil Cooler Intake Hose 6. Oil Cooler Outlet Hose 7. Cylinder Jacket 8. Cylinder Head Jacket 9. Thermostat Housing 10. Air Bleeder Hose 11. Radiator Cap 12. Radiator Overflow Hose 13. Reserve Tank 14. Reserve Tank Overflow Ho ...

Special Tools
Bearing Puller: 57001-135 Head Pipe Outer Race Press Shaft: 57001-1075 Steering Stem Nut Wrench: 57001-1100 Bearing Driver Set: 57001-1129 Steering Stem Bearing Driver, 42.5: 57001-1344 Steering Stem Bearing Driver Adapter, 41.5: 57001-1345 Head Pipe Outer Race Driver, 55: 57001- ...

Transmission Assy Assembly
Install the ball bearing [A] until it is bottomed. Turn the oil seal side to the bottom. Special Tool - Bearing Driver Set: 57001-1129 Install the bearing holder [B]. Turn the flat side to the bottom. Apply a non-permanent locking agent to the bearing holder bolts [C]. Tighten: ...