If the valve is open, replace the thermostat with a new one.
The thermostat must be completely submerged and must not touch the container sides or bottom. Suspend an accurate thermometer [B] in the water so that the heat sensitive portions [C] are located in almost the same depth.
It must not touch the container, either.
If the measurement is out of the specified range, replace the thermostat with a new one.
Thermostat Valve Opening Temperature
58 62°C (136
144°F)
Compression Damping Force Adjuster and Rebound
Damping Force Adjuster Adjustment
The compression damping force adjuster
and the rebound damping force
adjuster are located on top of each front
fork leg.
Turn the adjuster clockwise with a
screwdriver to increase damping
force.
Turn the adjuster counterclockwise
to decrease damping force.
NOTICE
Do not force to t ...
Starter Clutch Assembly
Install the one-way clutch [A] to the driven gear.
Face the circlip side of the one-way clutch to inside.
Install the new snap ring [B] to the one-way clutch.
Install the drive gear [C] while turn it counterclockwise [D].
Apply molybdenum disulfide oil solution to the needle
bearing ...
Liquid Gasket, Non-permanent Locking Agent
For applications that require Liquid Gasket or a
Non-permanent Locking Agent, clean the surfaces so
that no oil residue remains before applying liquid gasket or
non-permanent locking agent. Do not apply them excessively.
Excessive application can clog oil passages and
cause serious damage.
...