Kawasaki Ninja Service Manual: Throttle Body Assy Installation

Kawasaki Ninja Service Manual / Fuel System (DFI) / Throttle Body Assy / Throttle Body Assy Installation

Throttle Body Assy Installation


Throttle Body Assy Installation


Throttle Body Assy Removal
WARNINGGasoline is extremely flammable and can be explosive under certain conditions, creating the potential for serious burns. Make sure the area is well-ventilated and free from ...

Throttle Body Assy Disassembly
1. Throttle Body Assy 2. Subthrottle Valve Actuator 3. Idle Speed Control Valve Actuator 4. Main Throttle Sensor 5. Subthrottle Sensor 6. Primary Fuel Injectors 7. Delivery Pipe Assy NOTICE ...

Other materials:

Oil Level Inspection
If the oil has just been changed, start the engine and run it for severalminutes at idle speed. This fills the oil filter with oil. Stop the engine, then wait several minutes until the oil settles. NOTICE Racing the engine before the oil reaches every part can cause engine seizure. ...

Chassis Parts Lubrication
Before lubricating each part, clean off any rusty spots with rust remover and wipe off any grease, oil, dirt, or grime. Lubricate the points listed below with indicated lubricant. NOTE Whenever the vehicle has been operated under wet or rainy conditions, or especially after using a high ...

Turn Signal Switch
When the turn signal switch is pushed to the left ( ) or right ( ), the corresponding turn signals blink on and off. To stop blinking, push the switch in. Horn Button When the horn button is pushed, the horn sounds LAP/Passing Button When the LAP/passing button is pushed, the headlight hi ...