Kawasaki Ninja Service Manual: Throttle Grip and Cables

Kawasaki Ninja Service Manual / Fuel System (DFI) / Throttle Grip and Cables

Free Play Inspection

Refer to the Throttle Control System Inspection in the Periodic Maintenance chapter.

Free Play Adjustment

Refer to the Throttle Control System Inspection in the Periodic Maintenance chapter.

Cable Installation

Install the throttle cables in accordance with the Cable, Wire, and Hose Routing section in the Appendix chapter.
Install the lower ends of the throttle cables in the throttle pulley on the throttle body assy after installing the upper ends of the throttle cables in the grip.
After installation, adjust each cable properly (see Throttle Control System Inspection in the Periodic Maintenance chapter).

WARNING

Operation with incorrectly routed or improperly adjusted cables could result in an unsafe riding condition.

Be sure the cables are routed correctly and properly adjusted.

Cable Lubrication

Refer to the Chassis Parts Lubrication in the Periodic Maintenance chapter.

Fuel Injector Fuel Line Inspection

Remove: Fuel Tank (see Fuel Tank Removal) Air Cleaner Housing (see Air Cleaner Housing Removal) Disconnect: Primary and Secondary Fuel Hoses (see Fuel Hose Replacement in the Periodic Mai ...

Throttle Body Assy

Idle Speed Inspection Refer to the Idle Speed Inspection in the Periodic Maintenance chapter. Synchronization Inspection/Adjustment Refer to the Engine Vacuum Synchronization Inspection in the P ...

Other materials:

Brake Hose and Pipe Replacement
NOTICE Brake fluid quickly ruins painted plastic surfaces; any spilled fluid should be completely washed away immediately. Remove: Upper Fairing Assembly (see Upper Fairing Assembly Removal in the Frame chapter) Brake Hose Fitting Bolt [A] Brake Hose Banjo Bolts [B] Bolt [C] Clamp ...

Fuel Tank and Cap Inspection
Visually inspect the gasket [A] on the tank cap for any damage. Replace the gasket if it is damaged. Check to see if the water drain pipe [B] and fuel breather pipe [C] in the tank are not clogged. Check the tank cap breather also. If they are clogged, remove the tank and drain it ...

Oil Cooler Installation
Replace the O-ring [A] with a new one. Apply grease to the new O-ring. Install the water hoses and hose clamps [A] as shown in the figure. Water Hose (About 300 mm, 11.8 in.) [B] Water Hose (About 130 mm, 5.1 in.) [C] Yellow Paint [D] Tighten: Torque - Water Hose Clamp S ...