Kawasaki Ninja Service Manual: Tie-Rod, Rocker Arm

Swingarm Bearing, Sleeve Inspection

NOTICE Do not remove the bearings for inspection. Removal may damage them. Inspect the needle bearings [A] and ball bearing installed in the swingarm. The rollers and ball in a bearing ...

Tie-Rod Removal

Squeeze the brake lever slowly and hold it with a band [A]. Remove the front footpeg bracket bolts [A]. Raise the rear wheel off the ground with the jack (see Rear Shock Abs ...

Other materials:

Service Code Erasing
When repair has been done, warning indicator light (LED) and warning symbol go off and service code are not displayed. But the service codes stored in memory of the ECU are not erased to preserve the problem history. In this model, the problem history can not be erased. However, the memorie ...

Camshaft Installation
NOTE The exhaust camshaft has a 1001 EX mark [A] and the intake camshaft has a 3154 IN mark [B]. Be careful not to mix up these shafts. Install the camshaft sprockets as shown in the figure. #4 Cam Positions [A] Intake Camshaft Sprocket [B] Exhaust Camshaft Sprocket [C] The int ...

Idle Speed Control Valve Actuator Removal
NOTICE Never drop the idle speed control valve actuator especially on a hard surface. Such a shock to the actuator can damage it. Remove: Throttle Body Assy (see Throttle Body Assy Removal in the Fuel System (DFI) chapter) Idle Speed Control Valve Actuator Retainer Screws [A] Idle Spe ...