Kawasaki Ninja Service Manual: Timing Rotor Removal

Crankshaft Sensor Peak Voltage Inspection

NOTE Be sure the battery is fully charged. Using the peak voltage adapter [A] is more reliable way to determine the condition of the crankshaft sensor than crankshaft sensor internal resista ...

Timing Rotor Installation

Install the timing rotor [A] on the crankshaft [B] with their teeth [C] aligned. Holding the timing rotor with the flywheel & pulley holder and tighten the bolt. Torque - Timing Rotor ...

Other materials:

Rear Wheel Removal
Raise the rear wheel off the ground with the stand [A]. Remove: Cotter Pin [A] Rear Axle Nut [B] Washer [C] Rear Axle [D] (from Right Side) Remove the rear wheel rotation sensor from the caliper bracket (see Rear Wheel Rotation Sensor Removal in the Brakes chapter). ...

Subthrottle Sensor Resistance Inspection
Turn the ignition switch to OFF. Disconnect the subthrottle sensor connector. Connect a digital meter [A] to the subthrottle sensor connector [B]. Measure the subthrottle sensor resistance. Subthrottle Sensor Resistance Connections: BL lead [D] ←→ BR/BK lead [C] Standard: ...

Storage of Removed Parts
After all the parts including subassembly parts have been cleaned, store the parts in a clean area. Put a clean cloth or plastic sheet over the parts to protect from any foreign materials that may collect before re-assembly. Inspection Reuse of worn or damaged parts may lead to serious acci ...