Kawasaki Ninja Service Manual: Tire Repair

Kawasaki Ninja Service Manual / Wheels/Tires / Tires / Tire Repair

Currently two types of repair for tubeless tires have come into wide use. One type is called a temporary (external) repair which can be carried out without removing the tire from the rim, and the other type is called permanent (internal) repair which requires tire removal. It is generally understood that higher running durability is obtained by permanent (internal) repairs than by temporary (external) ones.

Also, permanent (internal) repairs have the advantage of permitting a thorough examination for secondary damage not visible from external inspection of the tire. For these reasons, Kawasaki does not recommend temporary (external) repair. Only appropriate permanent (internal) repairs are recommended. Repair methods may vary slightly from make to make. Follow the repair methods indicated by the manufacturer of the repair tools and materials so that safe results can be obtained.

Tire Installation
WARNINGSome replacement tires may adversely affect handling and cause an accident resulting in serious injury or death. To ensure proper handling and stability, use only the recomm ...

Hub Bearing
...

Other materials:

Transmission Shaft Assembly
Apply molybdenum disulfide oil solution to the sliding surfaces of the gears and shafts. Install the gears and the gear bushings [A] with their holes [B] aligned. Replace any circlips removed with new ones. Install the circlips [A] so that the opening [B] of it is aligned with ...

Air Intake Duct Disassembly (Other than US, CA and CAL Models)
Remove: Air Intake Duct (see Air Intake Duct Removal) Seal [A] and Screen [B] Turn the air intake valve actuator [C] counterclockwise (90В°). Remove the shaft [A] of the air intake valve actuator. Remove: Pad [A] Screws [B] Air Intake Valve [C] ...

Thermostat Installation
Replace the O-rings [A] with new ones, and apply grease to them. Assemble: O-rings Thermostat Housing [B] Thermostat [C] Thermostat Cap [D] Install the thermostat [A] in the housing so that the air bleeder hole [B] is on top. Tighten: Torque - Thermostat Cap Bolts: 5.9 N ...