If the transmission assy is to be disassembled, remove the following.
Shift Ratchet Assembly and Holder Gear Positioning Lever Bolt [A] Gear Positioning Lever [B], Spring [C] and Collar
US, CA and CAL Models
1. Hold the water hose [A]. Insert the tab into the slot.
2. Hold the water hose [B]. Insert the tab into the slot.
3. Water Hose Fitting on Cylinder Head
4. Heat Insulation Rubber Plate
5. Run the crankshaft sensor lead and the oil pressure switch lead into the
slot, and hook the slot
on ...
Oxygen Sensor Heater Power Source Voltage Inspection
NOTE
Be sure the battery is fully charged.
Turn the ignition switch to OFF.
Remove the fuel tank (see Fuel Tank Removal in the Fuel
System (DFI) chapter).
Disconnect the oxygen sensor lead connector and connect
the measuring adapter [A] between these connectors
as shown in the fig ...
Swingarm Bearing, Sleeve Inspection
NOTICE
Do not remove the bearings for inspection. Removal
may damage them.
Inspect the needle bearings [A] and ball bearing installed
in the swingarm.
The rollers and ball in a bearing normally wear very little,
and wear is difficult to measure. Instead of measuring,
visually inspec ...