Kawasaki Ninja Owners Manual: Trip Meters

Kawasaki Ninja Owners Manual / General information / Meter instruments / Multifunction Meter / Trip Meters

The trip meter has two meters which distinguished between the “TRIP A” and “TRIP B”. The trip meter shows the distance in kilometers or miles traveled since it was last reset to zero.

TRIP A: 0.0 9999.9

TRIP B: 0.0 9999.9

A. Trip Meter

B. “TRIP A”

To reset the trip meter:

Push the upper button to select the trip meter A or B.
Push the lower button and hold it in.

NOTE

The data is maintained by the back up power if the ignition switch is turned “OFF”.
When the trip meter reaches 9999.9 while riding, the meter resets to 0.0 and continues counting.
When the battery is disconnected, the meter display resets to 0.0.
The display unit modes can be changed, refer to the “Unit Setting” item in this section.

Odometer

The odometer shows the total distance in kilometers or miles that the vehicle has run. If the odometer is displayed, the “ODO” is displayed on the multifunction display. This meter cannot be ...

Current Mileage

This display mode shows the current mileage by numerical value. The current mileage display is renewed every 4 seconds. A. Current Mileage B. “km/L” NOTE The display unit modes can b ...

Other materials:

Front, Rear Wheel Rotation Difference Abnormal Inspection (Service Code b 25)
Check the following and correct the faulty part. Incorrect Tire Pressure Tires not recommended for the motorcycle were installed (incorrect tire size). Deformation of Wheel or Tire Missing Teeth or Clogging with Foreign Matter of Sensor Rotor (see Wheel Rotation Sensor Rotor Inspe ...

KIBS Hydraulic Unit Terminal Names
1. Ground: BK 2. CAN Communication Line (High): GY/BL 3. Front Wheel Rotation Sensor Signal Input: Y 4. Power Supply: BR/W 5. KIBS Kawasaki Self-Daignosis System Terminal: P 6. Front and Rear Brake Light Switch Signal: BL/R 7. Unused 8. Front Wheel Rotation Sensor Signal Output: G/Y 9. P ...

Special Tools and Sealant
Hand Tester: 57001-1394 Flywheel Puller Assembly, M38 × 1.5/M35 × 1.5: 57001-1405 Peak Voltage Adapter: 57001-1415 Lead Wire - Peak Voltage Adapter: 57001-1449 Key Registration Unit: 57001-1582 Grip: 57001-1591 Flywheel & Pulley Holder: 57001-1605 Rotor Holder: ...