When the turn signal switch is
pushed to the left ( ) or right
( ), the corresponding turn signals
blink on and off.
To stop blinking, push the switch in.
Horn Button
When the horn button is pushed, the horn sounds
LAP/Passing Button
When the LAP/passing button is pushed, the headlight high beam (passing beam) goes on to signal the driver of the vehicle ahead that you are about to pass. The passing light is shut off as soon as the button is released.
Refer to the “Stop Watch” items in Multifunction Meter section for the LAP button functions.
Power/S-KTRC Button
Refer to the S-KTRC or Power Mode System instructions of the “How to Ride the Motorcycle” chapter for operations.
Lower Fairing Removal
Remove the quick rivets [A].
Remove:
Quick Rivets [A]
Bolts [B]
Pull up the core by the flat-head screwdriver (–), and then
remove the quick rivet.
Clear the hook portions on the upper edges [C] from the
slots, and remove the left lower fairing [D].
While pulling down ...
Front Forks/Rear Shock Absorber Operation Inspection
Pump the forks down and up [A] 4 or 5 times, and inspect
the smooth stroke.
If the forks do not smoothly or noise is found, inspect the
fork oil level or fork clamps (see Front Fork Oil Change in
the Suspension chapter).
Pump the rear seat down and up [A] 4 or 5 times, and
inspec ...
Subthrottle Sensor Resistance Inspection
Turn the ignition switch to OFF.
Disconnect the subthrottle sensor connector.
Connect a digital meter [A] to the subthrottle sensor connector
[B].
Measure the subthrottle sensor resistance.
Subthrottle Sensor Resistance
Connections: BL lead [D] ←→ BR/BK lead [C]
Standard: ...