1. Hold the water hose [A]. Insert the tab into the slot.
2. Hold the water hose [B]. Insert the tab into the slot.
3. Water Hose Fitting on Cylinder Head
4. Heat Insulation Rubber Plate
5. Run the crankshaft sensor lead and the oil pressure switch lead into the slot, and hook the slot on the grommet of the crankshaft sensor [C].
6. Right Heat Insulation Rubber Plate
7. Run the crankshaft sensor lead to inside of the rubber plate.
8. Run the water hose [D], and hook the water hose clamp screw [E].
9. Insert the tabs into the slots.
10. Place this portion to inside of the right heat insulation rubber plate.
11. Thermostat
12. Run the gear position switch lead here.
13. Insert the tabs into the slots.
14. Left Heat Insulation Rubber Plate
Spark Plug Condition Inspection
Remove the spark plugs (see Spark Plug Replacement in
the Periodic Maintenance chapter).
Visually inspect the spark plugs.
If the spark plug center electrode [A] and/or side electrode
[B] are corroded or damaged, or if the insulator [C]
is cracked, replace the plug.
If the spark plug is ...
Multifunction Display
The multifunction display indicates
the following modes.
Odometer
Trip meter A
Trip meter B
Current Mileage
Average Mileage
Fuel Consumption
Stop Watch
These display modes can be shifted
by pushing the upper button.
NOTE
The “FUEL” warning can be indicated
if the ...
Refreshing Charge
Remove the battery (see Battery Removal).
Do refresh charge by following method according to the
battery terminal voltage.
WARNINGThis battery is sealed type. Charge with
current and
time as stated below.
Terminal Voltage: 12.0 12.7
V
Standard Charge (see following ...