Kawasaki Ninja Service Manual: Vacuum Chamber Removal (Other than US, CA and CAL Models)

Air Intake Solenoid Valve Installation (Other than US, CA and CAL Models)

Run the lead and hoses correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter). Tighten: Torque - Air Intake Solenoid Valve Nut: 7.0 N·m (0.71 kgf·m, 62 in·lb) A ...

Vacuum Chamber Installation (Other than US, CA and CAL Models)

Run the hoses correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter). Fit the projection [A] to the hollow [B]. ...

Other materials:

Terminal Numbers of ECU Connectors
1. Subthrottle Valve Actuator: Y/BK 2. Subthrottle Valve Actuator: BK/O 3. Unused 4. Front Wheel Rotation Sensor Signal: G/Y 5. Unused 6. Starter Lockout Switch: R/G 7. Gear Position Switch: G/R 8. Crankshaft Sensor (–): BK 9. Power Supply to Sensors: BL 10. Unused 11. Intake Air Pre ...

Coolant Level Inspection
Situate the motorcycle so that it is perpendicular to the ground. Check the coolant level through the coolant level gauge on the reserve tank located to the left of the engine. The coolant level should be between the “F” (Full) and “L” (Low) level lines. A. Reserve Ta ...

Lower Fairing Installation
Installation is the reverse of removal. Note the following. When installing the pad [A], align the edge of the pad and the marking of the fairing [B]. When installing the pad [C], align the edge of the pad and the fairing [D], and fit the edge of the pad to the boss [E]. Insert the hoo ...