Valve and valve seat wear decreases valve clearance, upsetting valve timing.
NOTICE
If valve clearance is left unadjusted, wear will eventually cause the valves to remain partly open; which lowers performance, burns the valves and valve seats, and may cause serious engine damage.
Valve clearance for each valve should be checked and adjusted in accordance with the Periodic Maintenance Chart.
Inspection and adjustment should be carried out only by a competent mechanic following the instructions in the Service Manual.
Brake Hose and Pipe Replacement
NOTICE
Brake fluid quickly ruins painted plastic surfaces;
any spilled fluid should be completely washed away
immediately.
Remove:
Upper Fairing Assembly (see Upper Fairing Assembly
Removal in the Frame chapter)
Brake Hose Fitting Bolt [A]
Brake Hose Banjo Bolts [B]
Bolt [C]
Clamp ...
Brakes
Brake Wear Inspection
Inspect the brakes for wear. For each
front and rear disc brake caliper, if the
thickness of either pad is less than
1 mm (0.04 in.), replace both pads
in the caliper as a set. Pad replacement
should be done by an authorized
Kawasaki dealer.
A. Lining Thickness
B. ...
Main Throttle Sensor Resistance Inspection
Turn the ignition switch to OFF.
Measure the main throttle sensor resistance in the same
way as input voltage inspection, note the following.
Disconnect the throttle sensor setting adapter [A] from the
connector of the main harness side.
Special Tool - Throttle Sensor Setting Adapter: 57 ...