NOTE
Valve clearance must be checked and adjusted when the engine is cold (at room temperature).
TDC Mark [A] for #1, 4 Pistons Timing Mark [B] (Crankcase Halves Mating Surface)
Valve Clearance
Standard:
Exhaust 0.17 0.22 mm (0.0067
0.0087 in.)
Intake 0.15 0.22 mm (0.0059
0.0087 in.)
NOTE
Thickness gauge is horizontally inserted on the valve lifter.
Appropriateness [A] Inadequacy [B] Thickness Gauge [C] Horizontally Inserts [D] Cam [E] Valve Lifter [F] Hits the Valve Lifter Ahead [G]
When positioning #1 piston TDC at the end of the compression stroke:
Intake Valve Clearance of #1 and #3 Cylinders Exhaust Valve Clearance of #1 and #2 Cylinders Measuring Valve [A]
When positioning #4 piston TDC at the end of the compression stroke:
Intake Valve Clearance of #2 and #4 Cylinders Exhaust Valve Clearance of #3 and #4 Cylinders Measuring Valve [A]
If the valve clearance is not within the specified range, first record the clearance, and then adjust it.
Water Temperature Sensor Removal/Installation
NOTICE
Never drop the water temperature sensor especially
on a hard surface. Such a shock to the sensor can
damage it.
Remove the throttle body assy (see Throttle Body Assy
Removal in the Fuel System (DFI) chapter).
Drain the coolant (see Coolant Change in the Periodic
Maintenance c ...
Vehicle-down Sensor Output Voltage Inspection
Remove the vehicle-down sensor.
Connect the measuring adapter [A] to the vehicle-down
sensor connectors as shown in the figure.
Special Tool - Measuring Adapter: 57001-1700
Main Harness [B]
Vehicle-down Sensor [C]
Connect a digital meter [D] to the measuring adapter
leads.
V ...
Service Code Erasing
When repair has been done, warning indicator light (LED) and warning symbol
go off and service
code are not displayed.
But the service codes stored in memory of the ECU are not erased to preserve
the problem history.
In this model, the problem history can not be erased. However, the memorie ...