Kawasaki Ninja Service Manual: Valve Guide Installation

Kawasaki Ninja Service Manual / Engine Top End / Valves / Valve Guide Installation

Apply engine oil to the valve guide outer surface before installation.
Heat the area around the valve guide hole to about 120
150°C (248 302°F).

NOTICE

Do not heat the cylinder head with a torch. This will warp the cylinder head. Soak the cylinder head and heat the oil.

Using the valve guide driver [A] and washer [B], press and insert the valve guide in until the valve guide driver surface [C] touches the head surface [D].

13.3 13.5 mm (0.52
0.53 in.) [E]

Special Tools - Valve Guide Driver: 57001-1564 Washer: 57001-1612

Valve Guide Installation

Ream the valve guide with valve guide reamer [A], even if the old guide is reused.

Special Tool - Valve Guide Reamer, 4.5: 57001-1333

Valve Guide Installation

Valve Guide Removal

Remove: Valve (see Valve Removal) Oil Seal Spring Seat Heat the area around the valve guide to 120 150°C (248 302°F), and hammer lightly on the valve guide arbor [A] to remove ...

Valve-to-Guide Clearance Measurement (Wobble Method)

If a small bore gauge is not available, inspect the valve guide wear by measuring the valve to valve guide clearance with the wobble method as indicated below. Insert a new valve [A] into the gu ...

Other materials:

Rear Wheel Rotation Sensor Wiring Inspection (Service Code b 45)
Disconnect the rear wheel rotation sensor lead connector [A] (see Rear Wheel Rotation Sensor Removal in the Brakes chapter). Disconnect the KIBS hydraulic unit lead connector (see KIBS Hydraulic Unit Removal in the Brakes chapter). Check the wiring continuity of the G lead and R ...

Precautions
There are a number of important precautions that are musts when servicing electrical systems. Learn and observe all the rules below. Do not reverse the battery cable connections. This will burn out the diodes on the electrical parts. Always check battery condition before condemning other ...

Brake Pedal Installation
Apply grease to the brake pedal pivot shaft [A]. Install: Washers [B] Brake Pedal [C] Apply a non-permanent locking agent to the threads of the brake pedal mounting bolt [D], and tighten it. Torque - Brake Pedal Mounting Bolt: 8.8 N·m (0.90 kgf·m, 78 in·lb) Install the re ...