NOTICE
Do not heat the cylinder head with a torch. This will warp the cylinder head. Soak the cylinder head in oil and heat the oil.
Special Tool - Valve Guide Arbor, 4.5: 57001-1331
Air Intake Solenoid Valve (Service Code 2d, Equipped Models)
Air Intake Solenoid Valve Removal/Installation
Refer to the Air Intake Solenoid Valve Removal/Installation
in the Fuel System (DFI) chapter.
Air Intake Solenoid Valve Inspection
Refer to the Air Intake Solenoid Valve Unit Test in the
Electrical System chapter.
If the air intake ...
Rear Sprocket Warp Inspection
Raise the rear wheel off the ground with the stand so that
it will turn freely.
Set a dial gauge [A] against the rear sprocket [B] near the
teeth as shown in the figure, and rotate [C] the rear wheel
to measure the sprocket runout (warp). The difference
between the highest and lowest di ...
Oxygen Sensor - not activated (Service Code 33, Equipped Models)
Oxygen Sensor Removal/Installation
Refer to the Oxygen Sensor Removal/Installation
(Equipped Models) in the Electrical System chapter.
Oxygen Sensor Inspection
Remove:
Fuel Tank (see Fuel Tank Removal in the Fuel System
(DFI) chapter)
Oxygen Sensor Lead Connector [A]
Connect t ...