Kawasaki Ninja Service Manual: Valve Installation

Kawasaki Ninja Service Manual / Engine Top End / Valves / Valve Installation

NOTICE

Do not lap the valve to the valve seat, using the grinding compound. It will come off oxide film treated surface of the valve.

Replace the oil seal with a new one.
Apply a thin coat of molybdenum disulfide grease to the valve stem before valve installation.
Install the springs so that the closed coil end faces downwards.

Valve Stem [A] Oil Seal [B] Spring Seat [C] Closed Coil End [D] Valve Spring [E]: EX - Yellow Paint IN - White Paint (∼ ZX100JBF/KBF Early Models) Purple Paint (ZX100JBF/KBF Late Models ∼) Retainer [F] Split Keepers [G]

Valve Installation

Valve Removal

Remove the cylinder head (see Cylinder Head Removal). Remove the valve lifter and shim. Mark and record the valve lifter and shim locations so they can be installed in their original position ...

Valve Guide Removal

Remove: Valve (see Valve Removal) Oil Seal Spring Seat Heat the area around the valve guide to 120 150°C (248 302°F), and hammer lightly on the valve guide arbor [A] to remove ...

Other materials:

Check 2-1: Speedometer Inspection
Using the suitable stand, raise the rear wheel off the ground. Rotate the rear wheel by hand or start the engine. Check that the display changes speedometer. If the display function does not work, check the following parts. Rear Wheel Rotation Sensor (see Wheel Rotation Sensor Inspe ...

Technical Information - Electronic Steering Damper (ESD/ZX1000JD/KD models)
1) Overview This model has an Electronic Steering Damper (ESD) [A]. Unlike conventional manual adjustment method of Kawasaki, damping characteristics are adjusted by the electronic control unit. 2) Purpose Designed to offer increased stability at high speed without interfering with light ...

Special Tools and Sealant
Oil Pressure Gauge, 10 kgf/cm²: 57001-164 Oil Pressure Gauge Adapter, PT3/8: 57001-1233 Outside Circlip Pliers: 57001-144 Liquid Gasket, TB1211: 56019-120 ...