If a small bore gauge is not available, inspect the valve guide wear by measuring the valve to valve guide clearance with the wobble method as indicated below.
If the reading exceeds the service limit, replace the guide.
NOTE
The reading is not actual valve/valve guide clearance because the measuring point is above the guide.
Valve/Valve Guide Clearance (Wobble Method) Standard:
Exhaust 0.03 0.12 mm (0.0012
0.0047 in.)
Intake 0.03 0.13 mm (0.0012
0.0051 in.)
Service Limit:
Exhaust 0.34 mm (0.013 in.)
Intake 0.36 mm (0.014 in.)
Precautions
1) No need of topping-up
No topping-up is necessary in this battery until it ends its life under
normal use. Forcibly prying
off the seal cap to add water is very dangerous. Never do that.
2) Refreshing charge.
Give refresh charge for 5 to 10 hours with charge current shown in the text
(see ...
Steering Damper Oil Leak Inspection
Visually inspect the steering damper [A] for oil leakage.
If the oil leakage is found on it, replace the steering
damper with a new one (see Steering Damper Removal/
Installation in the Steering chapter).
ZX1000JD/KD [B]
...
Air Switching Valve Removal
NOTICE
Never drop the air switching valve especially on a
hard surface. Such a shock to the air switching
valve can damaged it.
Remove the air cleaner housing (see Air Cleaner Housing
Removal in the Fuel System (DFI) chapter).
Disconnect the connector [A].
Disconnect the hoses [B] from ...