Kawasaki Ninja Service Manual: Vehicle-down Sensor Installation

Kawasaki Ninja Service Manual / Self-Diagnosis System / Vehicle-down Sensor (Service Code 31) / Vehicle-down Sensor Installation

Vehicle-down Sensor Installation


WARNING

Incorrect installation of the vehicle-down sensor could cause sudden loss of engine power. The rider could lose balance during certain riding situations for an accident resulting in injury or death.

Ensure that the vehicle-down sensor is held in place by the sensor bracket.

Vehicle-down Sensor Installation


Vehicle-down Sensor Removal
NOTICE Never drop the vehicle-down sensor especially on a hard surface. Such a shock to the sensor can damage it. Remove: Rear Seat (see Rear Seat Removal in the Frame chapter) Upper Seat Co ...

Vehicle-down Sensor Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Disconnect the vehicle-down sensor connector and connect the measuring adapter [A] between these connectors as sh ...

Other materials:

Precautions
There are a number of important precautions that are musts when servicing electrical systems. Learn and observe all the rules below. Do not reverse the battery cable connections. This will burn out the diodes on the electrical parts. Always check battery condition before condemning other ...

Swingarm Bearing, Sleeve Inspection
NOTICE Do not remove the bearings for inspection. Removal may damage them. Inspect the needle bearings [A] and ball bearing installed in the swingarm. The rollers and ball in a bearing normally wear very little, and wear is difficult to measure. Instead of measuring, visually inspec ...

Seat Cover Removal
Remove: Rear Seat (see Rear Seat Removal) Remove the bolts [A]. Remove the upper seat cover backward [B] to clear the hook portions. Remove: Front Seat (see Front Seat Removal) Quick Rivets [A] Bolts [B] Seat Covers [C] ...