Kawasaki Ninja Service Manual: Vehicle-down Sensor Output Voltage Inspection

Kawasaki Ninja Service Manual / Self-Diagnosis System / Vehicle-down Sensor (Service Code 31) / Vehicle-down Sensor Output Voltage Inspection

Remove the vehicle-down sensor.
Connect the measuring adapter [A] to the vehicle-down sensor connectors as shown in the figure.

Special Tool - Measuring Adapter: 57001-1700

Main Harness [B] Vehicle-down Sensor [C]

Connect a digital meter [D] to the measuring adapter leads.

Vehicle-down Sensor Output Voltage Inspection

Vehicle-down Sensor Output Voltage Connections to Adapter: Digital Meter (+) → W (sensor Y/G) lead Digital Meter (–) → BK (sensor BR/BK) lead

Vehicle-down Sensor Output Voltage Inspection

Hold the sensor vertically.
Measure the output voltage with the engine stopped, and with the connector joined.
Turn the ignition switch to ON.
Tilt the sensor 60 70° or
more [A] right or left, then hold the sensor almost vertical with the arrow mark pointed up [B], and measure the output voltage.

Output Voltage Standard: With sensor tilted 60
70° or more right or left: DC 0.65 1.35 V
With sensor arrow mark pointed up: DC 3.55 4.45 V

Turn the ignition switch to OFF.

If the reading is out of the standard, replace the sensor.

Vehicle-down Sensor Output Voltage Inspection

If the reading is within the standard, remove the ECU and check the wiring for continuity between main harness connectors.

Special Tool - Hand Tester: 57001-1394

Disconnect the ECU and sensor connectors.

Wiring Continuity Inspection ECU Connector [A] ←→ Vehicle-down Sensor Connector [B] Y/G lead (ECU terminal 38) [C] BR/BK lead (ECU terminal 13) [D]

Vehicle-down Sensor Output Voltage Inspection

If the wiring is good, check the ECU for its ground and power supply (see ECU Power Supply Inspection in the Fuel System (DFI) chapter).

If the ground and power supply are good, replace the ECU (see ECU Removal/Installation in the Fuel System (DFI) chapter).

Vehicle-down Sensor Circuit

Vehicle-down Sensor Circuit

1. ECU

2. Vehicle-down Sensor

Vehicle-down Sensor Input Voltage Inspection

NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Disconnect the vehicle-down sensor connector and connect the measuring adapter [A] between these connectors as sh ...

Subthrottle Sensor (Service Code 32)

The subthrottle sensor is a rotating variable resistor that change output voltage according to throttle operating. The ECU senses this voltage change and determines fuel injection quantity, and ign ...

Other materials:

Information for Coolant
To protect the cooling system (consisting of the aluminum engine and radiator) from rust and corrosion, the use of corrosion and rust inhibitor chemicals in the coolant is essential. If coolant containing corrosion and rust inhibitor chemicals are not used, over a period of time, the cooling ...

Tie-Rod and Rocker Arm Bearing Removal
Remove: Tie-Rod (see Tie-Rod Removal) Rocker Arms (see Rocker Arm Removal) Swingarm (see Swingarm Removal) Sleeves [A] Oil Seals [B] Remove the needle bearings [C], using the bearing remover head and bearing remover shaft. Special Tools - Bearing Remover Head, 15 × 17: ...

Related Parts Locations
KIBS Control 1. ABS performance equivalent to the current model (enhanced braking stability) By monitoring front caliper hydraulic pressure, KIBS regulates pressure increases reducing the tendency of the rear to lift. Before the ABS system fully reacts, KIBS system prevents the pressure ...