Kawasaki Ninja Service Manual: Water Pump Housing Assembly

Kawasaki Ninja Service Manual / Cooling System / Water Pump / Water Pump Housing Assembly

NOTICE

Do not reuse the mechanical seal and oil seal.

Special Tool - Bearing Driver Set: 57001-1129

Water Pump Housing Assembly


NOTICE

Be careful not to damage the sealing surface of the mechanical seal.

Special Tool - Oil Seal Driver 37.5: 57001-1660

Water Pump Housing Assembly


Water Pump Housing Disassembly
NOTICE Do not damage the hole wall of the water pump housing. Insert a bar [A] into the pump housing [B], and hammer evenly around the circumference of the mechanical seal bottom [C]. ...

Mechanical Seal Inspection
Remove the impeller (see Oil Pump Removal in the Engine Lubrication System chapter). Visually inspect the mechanical seal. If any one of the parts is damaged, replace the mechanical seal as ...

Other materials:

Replacement Parts
Replacement parts must be KAWASAKI genuine or recommended by KAWASAKI. Gaskets, O-rings, oil seals, grease seals, circlips, cotter pins or self-locking nuts must be replaced with new ones whenever disassembled. Assembly Order In most cases assembly order is the reverse of disassembly, howe ...

Race Mode Display
This mode gives priority to reading the gear position rather than the speedometer reading. The gear position indicator can be displayed at the position of the speedometer on the normal mode. Also the speedometer is displayed instead of the clock on the normal mode. This mode can be used ...

DFI System Wiring Diagram
Part Names 1. Air Intake Solenoid Valve (Other than US, CA and CAL Models) 2. Front Wheel Rotation Sensor 3. Engine Stop Switch 4. Starter Button 5. Air Switching Valve 6. Stick Coil #1, #2, #3, #4 7. Spark Plugs 8. Intake Air Temperature Sensor 9. Crankshaft Sensor 10. Secondary Fuel ...