Kawasaki Ninja Service Manual: Water Pump Housing Disassembly

Kawasaki Ninja Service Manual / Cooling System / Water Pump / Water Pump Housing Disassembly

NOTICE

Do not damage the hole wall of the water pump housing.

Insert a bar [A] into the pump housing [B], and hammer evenly around the circumference of the mechanical seal bottom [C].

Water Pump Housing Disassembly

Take the oil seal [A] out of the housing [B] with a hook [C].

Water Pump Housing Disassembly

Water Pump Impeller Inspection

Remove the water pump cover (see Oil Pump Removal in the Engine Lubrication System chapter). Visually inspect the impeller [A]. If the surface is corroded or if the blades are damaged, repl ...

Water Pump Housing Assembly

NOTICE Do not reuse the mechanical seal and oil seal. Apply high-temperature grease to the new oil seal lips [A]. Press the new oil seal into the housing with a bearing driver [B] until it st ...

Other materials:

Evaporative Emission Control System (California model only)
This system routes fuel vapors from the fuel system into the running engine or stores the vapors in a canister when the engine is stopped. Although no adjustments are required, a thorough visual inspection must be made at the intervals specified by the Periodic Maintenance Chart. Inspection ...

Special Tools and Sealants
Outside Circlip Pliers: 57001-144 Piston Pin Puller Assembly: 57001-910 Piston Ring Compressor Grip: 57001-1095 Piston Ring Compressor Belt, 67 79: 57001-1097 Bearing Driver Set: 57001-1129 Liquid Gasket, TB1216B: 92104-1064 Liquid Gasket, TB1207B: 92104-2068 ...

KIBS Hydraulic Unit Terminal Names
1. Ground: BK 2. CAN Communication Line (High): GY/BL 3. Front Wheel Rotation Sensor Signal Input: Y 4. Power Supply: BR/W 5. KIBS Kawasaki Self-Daignosis System Terminal: P 6. Front and Rear Brake Light Switch Signal: BL/R 7. Unused 8. Front Wheel Rotation Sensor Signal Output: G/Y 9. P ...