Kawasaki Ninja Service Manual: Water Temperature Sensor Resistance Inspection

Kawasaki Ninja Service Manual / Self-Diagnosis System / Water Temperature Sensor (Service Code 14) / Water Temperature Sensor Resistance Inspection

If the reading is within the standard, but the problem still exists, replace the ECU (see ECU Removal/Installation in the Fuel System (DFI) chapter).

Water Temperature Sensor Circuit

Water Temperature Sensor Circuit


1. ECU

2. Water Temperature Sensor

Water Temperature Sensor Output Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the throttle body assy (see Throttle Body Assy Removal in the Fuel System (DFI) chapter). Disconnect the w ...

Intake Air Pressure Sensor #2 (Service Code 16)
...

Other materials:

Main Throttle Sensor Output Voltage Inspection
Measure the output voltage at the main throttle sensor in the same way as input voltage inspection, note the following. Disconnect the main throttle sensor connector and connect the setting adapter [A] between these connectors. Special Tool - Throttle Sensor Setting Adapter: 57001 -15 ...

Rear Sprocket Removal
Remove the rear wheel (see Rear Wheel Removal in the Wheels/Tires chapter). NOTICE Do not lay the wheel on the ground with the disc facing down. This can damage or warp the disc. Place blocks under the wheel so that the disc does not touch the ground. Remove: Rear Sprocket Nu ...

Exhaust Butterfly Valve Cable Removal
Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Open the clamp [A] and free the cables. Slide the dust covers [B]. Loosen the locknuts [A], and turn the adjusters [B] to give the cable plenty of play. Remove the clamp [A]. Remove the up ...