Kawasaki Ninja Owners Manual: Wear Inspection

Kawasaki Ninja Owners Manual / Maintenance and adjustment / Drive Chain / Wear Inspection

Remove the left front footpeg bracket bolts.

A. Front Footpeg Bracket

B. Bolts

Remove the bolts and chain cover.

A. Bolts

B. Chain Cover

Stretch the chain taut either by using the chain adjusters, or by hanging a 10 kg (22 lb) weight on the chain.
Measure the length of 20 links on the straight part of the chain from the pin center of the 1st pin to the pin center of the 21st pin. Since the chain may wear unevenly, take measurements at several places.
If the length exceeds the service limit, the chain should be replaced.

A. Measure

B. Weight

Drive Chain 20-Link Length

NOTE

Install the chain cover and front footpeg bracket in the reverse order of removal.
Reinstall the left footpeg bracket so that both footpegs are same position.
Apply the nonpermanent locking agent to the chain cover front side bolt.

Tightening Torque

WARNING

For safety, use only the standard chain. It is an endless type and should not be cut for installation; have it installed by an authorized Kawasaki dealer.

Rotate the rear wheel to inspect the drive chain for damaged rollers, and loose pins and links.
Also inspect the sprockets for unevenly or excessively worn teeth, and damaged teeth.

NOTE

Sprocket wear is exaggerated for illustration.

See Service Manual for wear limits.

A. Good Teeth

B. Worn Teeth

C. Damaged Teeth

If there is any irregularity, have the drive chain and/or the sprockets replaced by an authorized Kawasaki dealer.

Chain Slack Adjustment

Remove the cotter pin, and loosen the axle nut. Loosen the left and right chain adjuster locknuts. A. Axle Nut B. Cotter Pin C. Adjuster D. Locknut If the chain is too loose, tu ...

Lubrication

Lubrication is necessary after riding through rain or on wet roads, or any time that the chain appears dry. Use a lubricant for sealed chains to prevent deterioration of chain seals. If the chain ...

Other materials:

DFI Servicing Precautions
There are a number of important precautions that should be followed servicing the DFI system. This DFI system is designed to be used with a 12 V sealed battery as its power source. Do not use any other battery except for a 12 V sealed battery as a power source. Do not reverse the battery ...

Brake Pedal Installation
Apply grease to the brake pedal pivot shaft [A]. Install: Washers [B] Brake Pedal [C] Apply a non-permanent locking agent to the threads of the brake pedal mounting bolt [D], and tighten it. Torque - Brake Pedal Mounting Bolt: 8.8 N·m (0.90 kgf·m, 78 in·lb) Install the re ...

Cylinder (Upper Crankcase) Wear Inspection
Split the crankcase (see Crankcase Splitting). Remove the pistons (see Piston Removal). Assemble the cylinder (upper crankcase) [A], the cylinder head [B] and the cylinder head gasket [C]. Tighten the cylinder head bolts (see Cylinder Head Installation in the Engine Top End chapter). ...