Kawasaki Ninja Service Manual: Wheel/Tire Damage Inspection

Kawasaki Ninja Service Manual / Periodic Maintenance / Periodic Maintenance Procedures / Wheels/Tires / Wheel/Tire Damage Inspection

If any damage is found, replace the wheel if necessary.

Wheel/Tire Damage Inspection


Tire Air Pressure Inspection
Remove the air valve cap. Measure the tire air pressure with an air pressure gauge [A] when the tires are cold (that is, when the motorcycle has not been ridden more than a mile during the pa ...

Tire Tread Wear Inspection
As the tire tread wears down, the tire becomes more susceptible to puncture and failure. An accepted estimate is that 90% of all tire failures occur during the last 10% of tread life (90% worn). So ...

Other materials:

Brake Fluid Leak (Brake Hose and Pipe) Inspection
For KIBS equipped models, remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Apply the brake lever or pedal and inspect the brake fluid leak from the brake hoses [A], pipes (KIBS equipped models) [B] and fittings [C]. If the brake fluid leaked from any posit ...

Radiator Hose and Pipe Inspection (coolant leak, damage, installation condition)
The high pressure inside the radiator hose can cause coolant to leak [A] or the hose to burst if the line is not properly maintained. Visually inspect the hoses for signs of deterioration. Squeeze the hoses. A hose should not be hard and brittle, nor should it be soft or swollen. Repl ...

Connecting Rod Big End Bearing Insert/Crankpin Wear Inspection
Remove the connecting rod big end (see Connecting Rod Removal). Cut strips of plastigage to crankpin width. Place a strip on the crankpin parallel to the crankshaft installed in the correct position. Tighten the connecting rod big end nuts to the specified torque (see Connecting Rod I ...