Kawasaki Ninja Service Manual: Wheels (Rims)

Special Tools

Bearing Driver Set: 57001-1129 Jack: 57001-1238 Bearing Remover Head, 25 × 28: 57001-1346 Bearing Remover Shaft, 13: 57001-1377 Jack Attachment: 57001-1608 ...

Front Wheel Removal

Remove: Front Caliper Mounting Bolts [A] (Both Sides) Front Caliper [B] (Both Sides) Loosen: Front Axle Clamp Bolts [A] (Right Side) Front Axle [B] Remove the lower fair ...

Other materials:

Electrical Leads
A two-color lead is identified first by the primary color and then the stripe color. Unless instructed otherwise, electrical leads must be connected to those of the same color. Instrument Use a meter that has enough accuracy for an accurate measurement. Read the manufacture’s instructions ...

Brake Pedal Removal
Remove: Rear Master Cylinder Mounting Bolts [A] Foot Guard [B] Screw and Stopper [C] Bolt [D] Front Footpeg Bracket Bolts [E] Cable Guide [F] Remove: Cotter Pin [A] Joint Pin [B] Rear Brake Light Switch Spring [C] Return Spring [D] Remove the brake pedal mounting b ...

Coupling Bearing Inspection
Since the coupling bearing is made to extremely close tolerances, the clearance can not normally be measured. NOTE It is not necessary to remove the coupling bearing for inspection. If the bearing is removed, it will need to be replaced with a new one. Turn the bearing in the coupling b ...