Kawasaki Ninja Service Manual: Wiring Diagram (US, CA and CAL with KIBS Models)

Kawasaki Ninja Service Manual / Electrical System / Wiring Diagram (US, CA and CAL with KIBS Models)

ZX1000KC

Wiring Diagram (US, CA and CAL with KIBS Models)


Wiring Diagram (US, CA and CAL with KIBS Models)


ZX1000KD

Wiring Diagram (US, CA and CAL with KIBS Models)


Wiring Diagram (US, CA and CAL with KIBS Models)


Wiring Diagram (US, CA and CAL without KIBS Models)
ZX1000JC ZX1000JD ...

Wiring Diagram (Other than US, CA and CAL without KIBS Models)
ZX1000JC ZX1000JD ...

Other materials:

Gear Position Indicator
The gear position indicator shows the corresponding gear positions where the transmission is shifted. For example, when the transmission is in 6th gear, “6” is displayed. A. Gear Position Indicator (Normal mode) NOTE If the gear position is in the neutral position, the gear positio ...

Oil Pan Installation
If the oil filter holder bolt [A] was removed, tighten it. Apply a non-permanent locking agent to the threads of the oil filter holder bolt. Torque - Oil Filter Holder Bolt: 35 N·m (3.6 kgf·m, 26 ft·lb) Replace the O-rings [B] with new ones, and apply grease to them. Install the O-ri ...

General Lubrication
Lubricate the points shown below, with either motor oil or regular grease, in accordance with the Periodic Maintenance Chart or whenever the vehicle has been operated under wet or rainy conditions. Before lubricating each part, clean off any rusty spots with rust remover and wipe off any g ...