Kawasaki Ninja Owners Manual: Battery Installation

Kawasaki Ninja Owners Manual / Maintenance and adjustment / Battery / Battery Installation

NOTICE

Installing the (–) cable to the (+) terminal of the battery or the (+) cable to the (–) terminal of the battery can seriously damaged the electrical system.

Battery Removal
Remove the rider’s seat (see Seats section in the GENERAL INFORMATION chapter). Turn the ignition switch to “OFF� and disconnect the (–) cable from the battery. Remove the red cap ...

Headlight Beam
NOTE Do not turn the bolts because the reflector in the headlight comes off. A. Bolts The left and right adjusters on the headlight can move the direction of the headlight beam to up, d ...

Other materials:

Oil Filter Replacement
Drain the engine oil (see Engine Oil Change). Remove the left lower fairing (see Lower Fairing Removal in the Frame chapter). Remove the oil filter [A] with the oil filter wrench [B]. Special Tool - Oil Filter Wrench: 57001-1249 Replace the filter with a new one. Apply grease t ...

Rear Shock Absorber Installation
Replace the rear shock absorber nuts and tie-rod nuts with new ones. Tighten: Torque - Rear Shock Absorber Nuts: 34 N·m (3.5 kgf·m, 25 ft·lb) Tie-Rod Nuts: 34 N·m (3.5 kgf·m, 25 ft·lb) When installing the rear shock absorber bracket [A], install it so that the recess side [B] ...

Battery Maintenance
It is the owner’s responsibility to keep the battery fully charged. Failure to do so can lead to battery failure and leave you stranded. If you are riding your vehicle infrequently, inspect the battery voltage weekly using a voltmeter. If it drops below 12.8 volts, the battery should be ...