Kawasaki Ninja Owners Manual: Battery Maintenance

Kawasaki Ninja Owners Manual / Maintenance and adjustment / Battery / Battery Maintenance

It is the owner’s responsibility to keep the battery fully charged. Failure to do so can lead to battery failure and leave you stranded.

If you are riding your vehicle infrequently, inspect the battery voltage weekly using a voltmeter. If it drops below 12.8 volts, the battery should be charged using an appropriate charger (check with your Kawasaki dealer).

If you will not be using the motorcycle for longer than two weeks, the battery should be charged using an appropriate charger. Do not use an automotive- type quick charger that may overcharge the battery and damage it.

NOTE

Leaving the battery connected causes the electrical components (clock etc) to make the battery discharged, resulting the over discharge of the battery. In this case, the repair or replacement of the battery is not included in the warranty. If you do not drive for four weeks or more, disconnect the battery from the vehicle.

Kawasaki-recommended chargers are:

Battery Mate 150-9

OptiMate 4

Yuasa MB-2040/2060

Christie C10122S

If the above chargers are not available, use equivalent one.

For more details, ask your Kawasaki dealer.

Battery Sulfation

A common cause of battery failure is sulfation. Sulfation occurs when the battery is left in a discharged condition for an extended time. Sulfate is a normal by product of the chemical reactions ...

Battery Charging

Remove the battery from the motorcycle (see Battery Removal). Attach the leads from the charger and charge the battery at a rate (amperage x hours) that is indicated on the battery. If it ...

Other materials:

Clutch
Clutch Operation Inspection Pull the clutch lever just enough to take up the free play [A]. Measure the gap between the lever and the lever holder. If the gap is too wide, the clutch may not release fully. If the gap is too narrow, the clutch may not engage fully. In either case, adjust ...

Evaporative Emission Control System (California model only)
This system routes fuel vapors from the fuel system into the running engine or stores the vapors in a canister when the engine is stopped. Although no adjustments are required, a thorough visual inspection must be made at the intervals specified by the Periodic Maintenance Chart. Inspection ...

DFI System Wiring Diagram
Part Names 1. Air Intake Solenoid Valve (Other than US, CA and CAL Models) 2. Front Wheel Rotation Sensor 3. Engine Stop Switch 4. Starter Button 5. Air Switching Valve 6. Stick Coil #1, #2, #3, #4 7. Spark Plugs 8. Intake Air Temperature Sensor 9. Crankshaft Sensor 10. Secondary Fuel ...