Kawasaki Ninja Service Manual: Cylinder Head Removal

Kawasaki Ninja Service Manual / Engine Top End / Cylinder Head / Cylinder Head Removal

Remove: Thermostat Housing (see Thermostat Removal in the Cooling System chapter) Exhaust Pipe (see Exhaust Pipe Removal) Camshafts (see Camshaft Removal) Heat Insulation Plate [A] (see Engine Removal in the Engine Removal/Installation chapter)
Place a container under the coolant drain bolt [B].
Drain the coolant by removing the coolant drain bolt.

Cylinder Head Removal

Remove the front camshaft chain guide bolt (upper) [A].

Cylinder Head Removal

Remove: Front Camshaft Chain Guide Bolt (Lower) [A] Collar Front Camshaft Chain Guide [B] Dowel Pin [C] Rear Camshaft Chain Guide [D]

Cylinder Head Removal

Loosen the M6 and M10 cylinder head bolts as shown sequence [1 12] in the figure,
and remove them with washers.
Remove the cylinder head forward.

Cylinder Head Removal

Cylinder Compression Measurement

NOTE Use the battery which is fully charged. Warm up the engine thoroughly. Stop the engine. Remove the spark plugs (see Spark Plug Replacement in the Periodic Maintenance chapter). Attac ...

Cylinder Head Installation

NOTE The camshaft cap is machined with the cylinder head, so if a new cylinder head is installed, use the cap that is supplied with the new head. Install the dowel pins. Replace the cylinder ...

Other materials:

Tire Installation
WARNINGSome replacement tires may adversely affect handling and cause an accident resulting in serious injury or death. To ensure proper handling and stability, use only the recommended standard tires for replacement, inflated to the standard pressure. Inspect the rim ...

Specifications
Connecting Rod Big End Bearing Insert Selection Crankshaft Main Bearing Insert Selection *: The bearing inserts for Nos. 2 and 4 journals have an oil groove, respectively. ...

Crankshaft Removal
Split the crankcase (see Crankcase Splitting). Remove: Connecting Rod Big End Nuts [A] Connecting Rod Big End Caps [B] NOTE Mark and record the locations of the connecting rods and their big end caps so that they can be reassembled in their original positions. Remove the crank ...