Kawasaki Ninja Service Manual: Oil Pan

Engine Oil Change

Refer to the Engine Oil Change in the Periodic Maintenance chapter. Oil Filter Replacement Refer to the Oil Filter Replacement in the Periodic Maintenance chapter. ...

Oil Pan Removal

Remove: Engine Oil (Drain, see Engine Oil Change in the Periodic Maintenance chapter) Exhaust Pipe (see Exhaust Pipe Removal in the Engine Top End chapter) Oil Filter (see Oil Filter Repl ...

Other materials:

Troubleshooting guide
Engine Does Not Start Starter Motor Won’t Turn Engine stop switch off Transmission not in neutral Fuse blown Battery leads do not make good electrical contact with battery terminals Battery discharged Engine Cranks, But Won’t Start No fuel in tank Fuel line clogged Fuel ...

Oil Pump Installation
Install the outer rotor [A] into the crankcase. Assemble: Oil (Water) Pump Shaft [B] Pin [C] Inner Rotor [D] To prevent dropping, apply grease to the pin. Install the inner rotor assembly into the crankcase. Fit the slot [E] onto the projection [F]. Replace the O-ring [A ...

Cylinder Compression Measurement
NOTE Use the battery which is fully charged. Warm up the engine thoroughly. Stop the engine. Remove the spark plugs (see Spark Plug Replacement in the Periodic Maintenance chapter). Attach the compression gauge [A] and adapter [B] firmly into the spark plug hole. Using the startermo ...