Kawasaki Ninja Owners Manual: Engine Vacuum Synchronization

Kawasaki Ninja Owners Manual / Maintenance and adjustment / Engine Vacuum Synchronization

Engine vacuum synchronization must be checked and adjusted periodically in accordance with the Periodic Maintenance Chart by an authorized Kawasaki dealer.

NOTE

Poor engine vacuum synchronization will cause unstable idling, sluggish throttle response, and reduce engine power and performance.

Throttle Control System

Check the throttle grip play each day before riding the motorcycle, and carry out maintenance and adjustments in accordance with the Periodic Maintenance Chart. Adjust it if necessary. Throttle G ...

Idle Speed

The idle speed inspection should be performed in accordance with the Periodic Maintenance Chart. This motorcycle is equipped with the Idle Speed Control valve. If the idle speed is disturbed, i ...

Other materials:

Air Intake Duct Assembly (Other than US, CA and CAL Models)
Install the seals [A] as shown in the figure. Fit the projections [A] of the air intake valve to the hole [B] of the air intake ducts. Tighten: Torque - Air Intake Duct Assembly Screws: 1.5 N·m (0.15 kgf·m, 13 in·lb) Hang the shaft [A] to the air intake valve securely ...

Axle Inspection
Remove the front and rear axles (see Front/Rear Wheel Removal). Visually inspect the front and rear axle for damages. If the axle is damaged or bent, replace it. Place the axle in V blocks that are 100 mm (3.94 in.) [A] apart, and set a dial gauge [B] on the axle at a point halfway ...

Rear Wheel Rotation Sensor Wiring Inspection (Service Code b 45)
Disconnect the rear wheel rotation sensor lead connector [A] (see Rear Wheel Rotation Sensor Removal in the Brakes chapter). Disconnect the KIBS hydraulic unit lead connector (see KIBS Hydraulic Unit Removal in the Brakes chapter). Check the wiring continuity of the G lead and R ...