Kawasaki Ninja Service Manual: Air Intake Solenoid Valve

Kawasaki Ninja Service Manual / Electrical System / Air Intake Solenoid Valve

Air Switching Valve
Air Switching Valve Operation Test Refer to the Air Suction System Damage Inspection in the Periodic Maintenance chapter. Air Switching Valve Unit Test Remove the air switching valve (see Air ...

Air Intake Solenoid Valve Operation Test
Start the engine and run it at idle speed. Check the air intake valve [A] as follows. When the engine is running, the air intake valve is lifting up. If the valve does not operate properly, ...

Other materials:

Premuffler Chamber Installation
Replace the premuffler chamber gasket [A] with a new one. Install the premuffler chamber gasket to the premuffler chamber [B] until it is bottomed so that the chamfer side faces exhaust pipe [C]. Install the exhaust pipe clamp [D] as shown in the figure. Insert the projection [E] into ...

Oxygen Sensor Heater Power Source Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the oxygen sensor lead connector and connect the measuring adapter [A] between these connectors as shown in the fig ...

Windshield
Windshield Removal Remove: Bolts [A] and Washers Windshield [B] Windshield Installation Be sure to install the wellnuts [A] and the washers. Tighten: Torque - Windshield Mounting Bolts: 1.2 N·m (0.12 kgf·m, 11 in·lb) ...