Kawasaki Ninja Service Manual: Brake Pedal Removal

Brake Pedal Position Adjustment

NOTE Usually it is not necessary to adjust the pedal position, but always adjust it when push rod locknut has been loosened. Loosen the locknut [A] and turn the push rod with the hex head [B] ...

Brake Pedal Installation

Apply grease to the brake pedal pivot shaft [A]. Install: Washers [B] Brake Pedal [C] Apply a non-permanent locking agent to the threads of the brake pedal mounting bolt [D], and tighten ...

Other materials:

ESD (Electronic Steering Damper) ECU Removal (ZX1000JD/KD)
NOTICE Never drop the ECU especially on a hard surface. Such a shock to the ECU can damage it. Lift up the front portion of the fuel tank, and hold it with a suitable bar or block (see Fuel Tank Removal in the Fuel System (DFI) chapter). NOTE When removing the ESD ECU only, there ...

Inquiries to Rider
Each rider reacts to problems in different ways, so it is important to confirm what kind of condition the rider is dissatisfied with. Try to find out exactly what problem occurs under exactly what conditions by asking the rider; knowing this information may help you reproduce the prob ...

Operating Procedures
Clean the seat area carefully. Coat the seat with machinist’s dye. Fit a 45° cutter into the holder and slide it into the valve guide. Press down lightly on the handle and turn it right or left. Grind the seating surface only until it is smooth. NOTICE Do not grind the seat too ...