Kawasaki Ninja Owners Manual: Front Footpeg Position

Kawasaki Ninja Owners Manual / General information / Front Footpeg Position

The right and left front footpegs can be selected to one of two positions to suit the front preferences. Have the front footpeg positions changed by an authorized Kawasaki dealer.

Front Footpeg Position


A. Bolts

B. Upper Position (Standard)

C. Lower Position

NOTE

Tightening Torque

Front Footpeg Bracket Bolts: 25 N·m (2.5 kgf·m, 18 ft·lb)

Air Cleaner Intake
The air cleaner intake allows air to enter the fuel system. Never allow anything to restrict the flow of air into the air cleaner. A restricted air cleaner will reduce performance and increase exh ...

Break-in
The first 1 600 km (1 000 mi) that the motorcycle is ridden is designated as the break-in period. If the motorcycle is not used carefully during this period, you may very well end up with a “b ...

Other materials:

Parts Location
1. Timing Rotor 2. Crankshaft Sensor 3. Horn 4. Oil Pressure Switch 5. Rear Brake Light Switch 6. Oxygen Sensor (Equipped Models) 7. Alternator 8. Stator Coil 9. Gear Position Switch 10. Sidestand Switch 11. Immobilizer Amplifier (Equipped Models) 12. Radiator Fan Motor 1 ...

Fuel Tank and Cap Inspection
Visually inspect the gasket [A] on the tank cap for any damage. Replace the gasket if it is damaged. Check to see if the water drain pipe [B] and fuel breather pipe [C] in the tank are not clogged. Check the tank cap breather also. If they are clogged, remove the tank and drain it ...

Rear Fender Front Installation
Installation is the reverse of removal. Note the following. Run the harness, cables and leads correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter). When installing the clamp [A] on the rear fender front [B], install it so that the clamp positions at near the ...