Kawasaki Ninja Service Manual: Gear Position Switch (Service Code 25)

Rear Wheel Rotation Sensor Signal (Service Code 24)

Rear Wheel Rotation Sensor Signal Inspection The rear wheel rotation sensor sends the signal to the ECU through the KIBS hydraulic unit (KIBS equipped models). For other than KIBS equipped models, ...

Gear Position Switch Removal/Installation

Refer to the Gear Position Switch Removal/Installation in the Electrical System chapter. Gear Position Switch Resistance Inspection Refer to the Gear Position Switch Inspection in the Elec ...

Other materials:

Warning/Indicator Lights
: When the transmission is in neutral, the neutral indicator light goes on. : When the headlight is on high beam, the high beam indicator light goes on. : When the turn signal switch is pushed to the left or right, the turn signal indicator light blinks. ...

Front Wheel Removal
Remove: Front Caliper Mounting Bolts [A] (Both Sides) Front Caliper [B] (Both Sides) Loosen: Front Axle Clamp Bolts [A] (Right Side) Front Axle [B] Remove the lower fairings (see Lower Fairing Removal in the Frame chapter). Raise the front wheel off the ground. ...

Oxygen Sensor Installation (Equipped Models)
NOTICE Never drop the oxygen sensor [A] especially on a hard surface. Such a shock to the unit can damage it. Do not touch the sensing part [B] to prevent oil contact. Oil contamination from hands can reduce sensor performance. Tighten: Torque - Oxygen Sensor: 25 N·m (2.5 kgf·m, 18 ...