Kawasaki Ninja Service Manual: Gear Position Switch Removal/Installation

Gear Position Switch (Service Code 25)

...

Gear Position Switch Output Voltage Inspection

NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the sidestand switc ...

Other materials:

Fuel Tank
The following octane rating gasoline is recommended for the fuel tank. Avoid filling the tank in the rain or where heavy dust is blowing so that the fuel does not get contaminated. A. Tank Cap B. Fuel Tank C. Top Level D. Filler Neck WARNINGGasoline is extremely flammable an ...

Brakes
Brake Wear Inspection Inspect the brakes for wear. For each front and rear disc brake caliper, if the thickness of either pad is less than 1 mm (0.04 in.), replace both pads in the caliper as a set. Pad replacement should be done by an authorized Kawasaki dealer. A. Lining Thickness B. ...

Battery
The battery installed in this motorcycle is a sealed type, so it is not necessary to check the battery electrolyte level or add distilled water. The sealing strip should not be pulled off once the specified electrolyte has been installed in the battery for initial service. However, in or ...