Kawasaki Ninja Service Manual: Operational Cautions

Kawasaki Ninja Service Manual / Electrical System / Immobilizer System (Equipped Models) / Operational Cautions

1. Do not put two keys of any immobilizer system on the same key ring.

2. Do not submerge any key in water.

3. Do not expose any key to excessively high temperature.

4. Do not place any key close to magnet.

5. Do not place a heavy item on any key.

6. Do not grind any key or alter its shape.

7. Do not disassemble the plastic part of any key.

8. Do not drop the key and/or apply any shocks to the key.

9. When a ignition key is lost, the user should go to his dealer to invalidate the lost key registration in the ECU.

10.When the all ignition keys are lost, the user should go to his dealer and have a new ECU installed and register the ignition keys.

NOTE

No.9 and 10 are strongly recommended to the customer to ensure security of the motorcycle.

Immobilizer System (Equipped Models)

This motorcycle is equipped with an immobilizer system to protect the motorcycle from theft. This system provides a theft proof device by means of matching a code between the inbuilt key transpon ...

Key Registration

Case 1: When the ignition key has been lost or additional spare ignition key is required. Prepare a new spare ignition key. Cut the key in accordance with the shape of the current ignition ke ...

Other materials:

Engine Stop Switch Operation Inspection
First Step Set the gear position in the neutral position. Turn the ignition switch to ON. Turn the engine stop switch to stop position [A]. Push the starter button. The engine does not start. If the engine starts, inspect the engine stop switch (see Switch Inspection in the Electri ...

Coolant Temperature Meter
The coolant temperature gauge indicates temperature of the engine coolant. The “ ” symbol is displayed if the coolant temperature meter is selected. A. Coolant Temperature Meter B. Warning Indicator Light (Red) C. “ ” Symbol If the coolant temperature is below 40°C (104°F ...

Operating Procedures
Clean the seat area carefully. Coat the seat with machinist’s dye. Fit a 45° cutter into the holder and slide it into the valve guide. Press down lightly on the handle and turn it right or left. Grind the seating surface only until it is smooth. NOTICE Do not grind the seat too ...