First Step
If the engine starts, inspect the engine stop switch (see Switch Inspection in the Electrical System chapter).
Second Step
If the engine does not stop, inspect the engine stop switch (see Switch Inspection in the Electrical System chapter).
If the engine stop switch is good condition, replace the ECU (see ECU Removal/Installation in the Fuel System (DFI) chapter).
Camshaft Chain Tensioner Installation
Replace the O-ring [A] with a new one.
Apply grease to the new O-ring.
Release the stopper [B] and push the push rod [C] into the
interior of the tensioner body [D] so that the position of the
push rod is 3 or 4 notches [E] as shown in the figure.
Install the tensioner body so that the ...
Storage
Preparation for Storage
Clean the entire vehicle thoroughly
Run the engine for about five minutes to warm the oil, shut it off, and
drain the
engine oil.
WARNINGEngine oil is a toxic substance. Dispose
of used oil properly. Contact
your local authorities for approved disp ...
Starter Motor Installation
NOTICE
Do not tap the starter motor shaft or body. Tapping
the shaft or body could damage the motor.
Clean the starter motor legs [A] and crankcase where the
starter motor is ground.
Replace the O-ring [A] with a new one.
Apply grease to the new O-ring.
Tighten:
Torque - Starter ...