Kawasaki Ninja Service Manual: Brake Fluid

Kawasaki Ninja Service Manual / Brakes / Brake Fluid

Brake Disc Warp Inspection
Raise the wheel off the ground with the jack. Special Tools - Jack: 57001-1238 Jack Attachment: 57001-1608 For front disc inspection, turn the handlebar fully to one side. Set up a dial ...

Brake Fluid Level Inspection
Refer to the Brake Fluid Level Inspection in the Periodic Maintenance chapter. Brake Fluid Change Refer to the Brake Fluid Change in the Periodic Maintenance chapter. ...

Other materials:

Piston Wear Inspection
Measure the outside diameter [A] of each piston 5 mm (0.20 in.) [B] up from the bottom of the piston at a right angle to the direction of the piston pin. If the measurement is under service limit, replace the piston. Piston Diameter Standard: 75.959 75.974 mm (2.9905 2.9911 in.) ...

Battery Ground
Before completing any service on the motorcycle, disconnect the battery cables from the battery to prevent the engine from accidentally turning over. Disconnect the ground cable (–) first and then the positive (+). When completed with the service, first connect the positive (+) cable to the p ...

Gear Position Switch Inspection
NOTE Be sure the transmission and external shift mechanism are good condition. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the connector [A]. Set the hand tester [A] to the × 1 kΩ or × 100 Ω range and connect i ...