Refer to the Brake Fluid Level Inspection in the Periodic Maintenance chapter.
Brake Fluid Change
Refer to the Brake Fluid Change in the Periodic Maintenance chapter.
Brake Fluid
Brake Line BleedingCylinder Compression Measurement
NOTE
Use the battery which is fully charged.
Warm up the engine thoroughly.
Stop the engine.
Remove the spark plugs (see Spark Plug Replacement in
the Periodic Maintenance chapter).
Attach the compression gauge [A] and adapter [B] firmly
into the spark plug hole.
Using the startermo ...
Water Temperature Sensor Resistance Inspection
Refer to the Water Temperature Sensor Inspection in the
Electrical System chapter.
If the reading is within the standard, but the problem still
exists, replace the ECU (see ECU Removal/Installation in
the Fuel System (DFI) chapter).
Water Temperature Sensor Circuit
1. ECU
2. Water T ...
Interlock Operation Inspection
Raise the rear wheel off the ground with the stand [A].
1st Check
Start the engine to the following conditions
Condition:
Transmission Gear → 1st Position
Clutch Lever → Release
Sidestand → Down or Up
Turn the ignition switch to ON and push the starter butto ...