When either the front or rear brake is applied, the brake light goes on. The front brake light switch requires no adjustment, but the rear brake light switch should be adjusted in accordance with the Periodic Maintenance Chart.
Inspection
A. Brake Pedal
B. 10 mm (0.4 in.)
C. Bolts
Brake Pedal Travel
Adjustment
A. Rear Brake Light Switch
B. Adjusting Nut
C. Lights sooner
D. Lights later
E. Viewed from behind the bracket
NOTICE
To avoid damaging the electrical connections inside the switch, be sure that the switch body does not turn during adjustment.
NOTE
Install the front footpegs with same height on both sides. Refer to the Front Footpeg Position in General Information chapter.
Clock
To adjust hours and minutes, do the
followings while the motorcycle is at a
stop.
Turn the ignition switch to “ON”.
Display the odometer in the multifunction
display. Refer to the “Multifunction
Display” item in this section.
Push the lower button for more than
2 seconds. Bot ...
Lights and Switches Operation Inspection
First Step
Set the gear position in the neutral position.
Turn the ignition switch to ON.
The following lights should go on according to below table.
If the following light does not go on, inspect the meter
unit (see Meter Unit Inspection in the Electrical System
chapter).
...
Transmission Assy Removal
Remove:
Engine Sprocket (see Engine Sprocket Removal in the
Final Drive chapter)
Gear Position Switch (see Gear Position Switch Removal
in the Electrical System chapter)
Collar [A]
O-ring [B]
Remove:
Clutch (see Clutch Removal in the Clutch chapter)
Shift Shaft Assembly ...