Kawasaki Ninja Service Manual: Brake Operation Inspection

Kawasaki Ninja Service Manual / Periodic Maintenance / Periodic Maintenance Procedures / Brakes / Brake Operation Inspection

If the brake operation is insufficiency, inspect the brake system.

WARNING

When test riding the vehicle, be aware of surrounding traffic for your safety.

Brake Pad Wear Inspection
Remove the brake pads (see Front/Rear Brake Pad Removal in the Brakes chapter). Check the lining thickness [A] of the pads in each caliper. If the lining thickness of either pad is less ...

Brake Light Switch Operation Inspection
Turn the ignition switch to ON. The brake light (LED) [A] should go on when the brake lever is applied or after the brake pedal is depressed about 10 mm (0.39 in.). If it does not, adj ...

Other materials:

Coolant Deterioration Inspection
Remove the right lower fairing (see Lower Fairing Removal in the Frame chapter). Visually inspect the coolant in the reserve tank [A]. If whitish cotton-like wafts are observed, aluminum parts in the cooling system are corroded. If the coolant is brown, iron or steel parts are rusting. I ...

Spring Tension Inspection
Since a spring becomes shorter as it weakens, check its free length [A] to determine its condition. If the spring of either fork leg is shorter than the service limit, it must be replaced. If the length of a replacement spring and that of the remaining spring vary greatly, the remaining s ...

Front Fork Disassembly
Remove the front fork (see Front Fork Removal (Each Fork Leg)) Drain the fork oil (see Front Fork Oil Change). Take the dust seal [A] off the outer tube. Remove the retaining ring [B]. Separate the outer tube from the inner tube. Remove the following parts from the inner tube. ...