Kawasaki Ninja Service Manual: Subthrottle Valve Actuator Resistance Inspection

Kawasaki Ninja Service Manual / Self-Diagnosis System / Subthrottle Valve Actuator (Service Code 62) / Subthrottle Valve Actuator Resistance Inspection

Turn the ignition switch to OFF.
Disconnect the subthrottle valve actuator connector [A].

Subthrottle Valve Actuator Resistance Inspection

Connect a digital meter to the subthrottle valve actuator connector [A].
Measure the subthrottle valve actuator resistance.

Subthrottle Valve Actuator Resistance Connections: Y/BK lead [1] ←→ P/BL lead [2] G lead [3] ←→ BK/O lead [4] Standard: About 6.3 9.5 Ω

Subthrottle Valve Actuator Resistance Inspection

If the reading is out of the standard, replace the throttle body assy.

If the reading is within the standard, check the input voltage (see Subthrottle Valve Actuator Input Voltage Inspection).

Subthrottle Valve Actuator Inspection

NOTE Be sure the battery is fully charged. Remove the air cleaner housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter). Turn the ignition switch to ON. Check to see th ...

Subthrottle Valve Actuator Input Voltage Inspection

NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Disconnect the subthrottle valve actuator connector and connect the measuring adapter [A] between these connect ...

Other materials:

Engine Oil Change
Situate the motorcycle so that it is vertical after warming up the engine. Remove the engine oil drain bolt [A] to drain the oil. The oil in the oil filter can be drained by removing the filter (see Oil Filter Replacement). Replace the drain bolt gasket [B] with a new one. Tighten t ...

Air Intake Duct Removal
Remove: Upper Fairing Assembly (see Upper Fairing Assembly Removal in the Frame chapter) Meter Bracket (see Meter Unit Removal/Installation in the Electrical System chapter) Immobilizer Amplifier [A] (Equipped Models) (see Immobilizer System Parts Replacement in the Electrical System ...

City Light (LED) Removal/Installation
Remove: Upper Fairing Assembly (see Upper Faring Assembly Removal in the Frame chapter) Headlight (see Headlight Removal) Remove the screws [A], and take the city light [B] off the upper fairing assembly. Installation is the reverse of removal. Note the following. When inst ...