Kawasaki Ninja Service Manual: Camshaft Chain Installation

Kawasaki Ninja Service Manual / Engine Top End / Camshaft, Camshaft Chain / Camshaft Chain Installation

Camshaft Chain Installation


Camshaft Chain Removal
Remove: Camshafts (see Camshaft Removal) Timing Rotor (see Timing Rotor Removal in the Electrical System chapter) Front and Rear Camshaft Chain Guides (see Cylinder Head Removal) Remove ...

Cylinder Head
...

Other materials:

Brake Fluid Change
NOTE The procedure to change the front brake fluid is as follows. Changing the rear brake fluid is the same as for the front brake. Level the brake fluid reservoir. Remove: Screw [A] Stopper [B] Front Brake Reservoir Cap [C] Diaphragm Plate Diaphragm Remove the rubb ...

Cable, Wire, and Hose Routing
1. Clamp (Hold the regulator/rectifier lead. Run the lead inside of the installation hole.) 2. Clamp (Bend down the clamp, and hold the main harness and the vacuum hose (equipped models).) 3. Clamp (Hold the air intake solenoid valve lead (equipped models).) 4. Run the vacuum hose under ...

Radiator Fan Relay Inspection
Refer to the Relay Circuit Inspection in the Electrical System chapter If the radiator fan relay is normal, check the wiring for continuity, using the wiring diagram in this section. Special Tool - Hand Tester: 57001-1394 If the wiring is good, check the ECU for its ground and power supp ...