Kawasaki Ninja

Kawasaki Ninja Service Manual: Diode Circuit Inspection

Kawasaki Ninja Service Manual / Electrical System / Relay Box / Diode Circuit Inspection

Diode Circuit Inspection


The resistance should be low in one direction and more than 10 times as much in the other direction. If any diode shows low or high in both directions, the diode is defective and the relay box must be replaced.

NOTE

The actual meter reading varies with the meter or tester used and the individual diodes, but generally speaking, the lower reading should be from zero to one half the scale.

Relay Box Internal Circuit

Relay Box Internal Circuit


A: Headlight Circuit Relay

B: ECU Main Relay

C: Fuel Pump Relay

D: Starter Circuit Relay

E: Fan Relay

Relay Circuit Inspection
Remove the relay box (see Relay Box Removal). Check conductivity of the following numbered terminals by connecting the hand tester and one 12 V battery to the relay box as shown in the figure ...

Fuse
...

Other materials:

Electronic Steering Damper Warning Indicator Light
The yellow light functions as the electronic steering damper warning indicator. The light and warning symbol "ESD" go on if there is a malfunction in the electronic steering damper system. However, this could also be caused by trouble with the charging system (e.g. battery). I ...

Air Cleaner Element Replacement
NOTE In dusty areas, the element should be replaced more frequently than the recommended interval. WARNINGIf dirt or dust is allowed to pass through into the throttle body assy, the throttle may become stuck, possibly causing accident. Replace the air cleaner element according ...

General Lubrication
Lubricate the points shown below, with either motor oil or regular grease, in accordance with the Periodic Maintenance Chart or whenever the vehicle has been operated under wet or rainy conditions. Before lubricating each part, clean off any rusty spots with rust remover and wipe off any g ...