Special Tool - Hand Tester: 57001-1394
Exhaust Butterfly Valve Actuator Resistance
Connections: P lead ←→ GY lead
Standard: 5 
200 Ω (for reference)
If the reading is 0 or infinity (∞) Ω, replace the exhaust butterfly valve actuator.
If the reading is in specification, remove the ECU and check the wiring for continuity between main harness connectors.
Disconnect the ECU and actuator connectors.
Wiring Inspection ECU Connector [A] ←→ Exhaust Butterfly Valve Actuator Connector [B] W/R lead (ECU terminal 45) [C] W/BL lead (ECU terminal 46) [D]
If the wiring is good, check the ECU for its ground and power supply (see ECU Power Supply Inspection in the Fuel System (DFI) chapter).
If the ground and power supply are good, replace the ECU (see ECU Removal/Installation in the Fuel System (DFI) chapter).
Exhaust Butterfly Valve Actuator Circuit
1. ECU
2. Exhaust Butterfly Valve Actuator
Exhaust Butterfly Valve Actuator Inspection
Air Switching Valve (Service Code 64)Economical Riding Indicator
When the operator is driving the motorcycle
for optimum fuel-efficiency, the
economical riding indicator appears on
the multifunction meter to indicate favorable
fuel consumption. Monitoring
the economical riding indicator can
help the rider maximize fuel efficiency.
A. Economical Riding ...
Meter Unit Circuit (ZX1000J Model)
1. Ignition Switch
2. Joint Connector F
3. Stop Watch Button
4. Oil Pressure Switch
5. Crankshaft Sensor
6. Water Temperature Sensor
7. Gear Position Switch
8. Intake Air Temperature Sensor
9. ESD ECU (ZX1000JD/KD)
10. ECU
11. Rear Wheel Rotation Sensor
12. Engine Ground
13. Battery ...
Lighting System
This motorcycle adopt the daylight system and have a
headlight relay in the relay box. The headlight does not
go on when the ignition switch and the engine stop switch
are first turned on. The headlight comes on after the starter
button is released and stays on until the ignition switch is
turn ...