Kawasaki Ninja Service Manual: Lighting System

Kawasaki Ninja Service Manual / Electrical System / Lighting System

This motorcycle adopt the daylight system and have a headlight relay in the relay box. The headlight does not go on when the ignition switch and the engine stop switch are first turned on. The headlight comes on after the starter button is released and stays on until the ignition switch is turned off. The headlight will go out momentarily whenever the starter button is pressed and come back on when the button is released.

Headlight Beam Horizontal Adjustment

Headlight Beam Vertical Adjustment

Refer to the Headlight Aiming Inspection in the Periodic Maintenance chapter.

Starter Relay Inspection
Remove the front seat (see Front Seat Removal in the Frame chapter). Remove the battery negative (–) cable from the battery negative (–) terminal (see Battery Removal). Take the starter ...

Headlight Bulb Replacement
Turn the cover [A] counterclockwise, and remove it. Disconnect the headlight connector [A]. Open the clamp [B], and remove the bulb. NOTICE When handling the quartz-halogen bulb, ne ...

Other materials:

Crankshaft Sensor Removal
Remove: Fuel Tank (see Fuel Tank Removal in the Fuel System (DFI) chapter) Crankshaft Sensor Lead Connector [A] Remove: Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Bolts [A] Crankshaft Sensor Cover [B] and Gasket Oil Pressure Switch Terminal [C] ...

Brake Disc Wear Inspection
Measure the thickness of each disc [A] at the point where it has worn the most. If the disc has worn past the service limit, replace it. Measuring Area [B] Brake Disc Thickness Standard: Front 5.3 5.7 mm (0.21 0.22 in.) Rear 4.8 5.2 mm (0.19 0.20 in.) Service Limit: Front 5. ...

Piston Ring Thickness Inspection
Measure the piston ring thickness. Use the micrometer to measure at several points around the ring. Piston Ring Thickness Standard: Top [A] 0.77 0.79 mm (0.0303 0.0311 in.) Second [B] 0.78 0.79 mm (0.0307 0.0311 in.) Service Limit: Top 0.70 mm (0.0276 in.) Second 0.71 mm (0.0280 ...