If the fuel pump relay is normal, check the wiring to the fuel pump relay (see Fuel Pump Relay Circuit).
Special Tool - Hand Tester: 57001-1394
If the wiring is good, check the ECU for its ground and power supply (see ECU Power Supply Inspection in the Fuel System (DFI) chapter).
If the ground and power supply are good, replace the ECU (see ECU Removal/Installation in the Fuel System (DFI) chapter).
Fuel Pump Relay Circuit
1. ECU
2. Engine Stop Switch
3. Ignition Switch
4. Joint Connector F
5. Fuse Box 1
6. Ignition Fuse 15 A
7. Relay Box
8. Fuel Pump Relay
9. Fuel Pump
10. Frame Ground 1
11. Frame Ground 3
12. Starter Relay
13. ECU Fuse 15 A
14. Main Fuse 30 A
15. Battery
16. Engine Ground
Stick Coil #1: Service Code 51
Stick Coil #2: Service Code 52
Stick Coil #3: Service Code 53
Stick Coil #4: Service Code 54
Oil and/or Oil Filter Change
To change the engine oil and replace
oil filter, the engine oil drain bolt and
oil filter must be removed. The oil
change and oil filter replacement
should be done by an authorized
Kawasaki dealer.
A. Engine Oil Drain Bolt
A. Oil Filter
WARNINGEngine oil is a toxic s ...
Headlight Beam
NOTE
Do not turn the bolts because the reflector
in the headlight comes off.
A. Bolts
The left and right adjusters on the
headlight can move the direction of
the headlight beam to up, down, left
and right by turning each adjuster itself
as the below table.
A. Left Adjuster
...
Cam Wear Inspection
Remove the camshafts (see Camshaft Removal).
Measure the height [A] of each cam with a micrometer.
If the cams are worn down past the service limit, replace
the camshaft.
Cam Height
Standard:
Exhaust 35.043 35.157 mm
(1.3796 1.3841 in.)
Intake 38.243 38.357 mm
(1.5056 1.5101 in. ...